Hi Haskell Users, Thanks in advance. At DOS prompt, I have typed: \ghc>cabal install hsc3 The following message appears: Warning: The package list for 'hackage.haskell.org' does not exist. Run 'cabal update' to download it. cabal: There is no package named hsc3. Perhaps you need to run 'cabal update' first? At DOS prompt, I typed: \ghc> cabal update The following message appears: Downloading the latest package list from hackage.haskell.org cabal: failed Is there any solution for it please? What will be the procedure, if I download first and then install (Is there any set of commands here?) Once again, thank you very much for the time you have given. Regards, Deb --- On Fri, 17/9/10, Deb Midya <debmidya@yahoo.com> wrote: From: Deb Midya <debmidya@yahoo.com> Subject: [Haskell-beginners] Installing package hsc3 – Haskell supercollider To: beginners@haskell.org Received: Friday, 17 September, 2010, 2:14 PM Hi Haskell Users, Thanks in advance. I am using Haskell on Windows XP. I have downloaded HaskellPlatform-2010.2.0.0-setup.exe and installed it. I have checked that GHCi version is 6.12.3. May I request you to assist me for the following please: To install Haskell supercollider package, I have downloaded hsc3-0.7.tar.gz. How can I install this package now? Is there any document (how to use) on this package? To assist me for this, I have also checked that whether cabal is working or not. To do that: At dos prompt: \ghc>cabal –help \ghc> cabal install –help It shows me flags for help and installation. Once again, thank you very much for the time you have given. Regards, Deb -----Inline Attachment Follows----- _______________________________________________ Beginners mailing list Beginners@haskell.org http://www.haskell.org/mailman/listinfo/beginners