#11041: EventLog write fails if entire buffer is not written -------------------------------------+------------------------------------- Reporter: sseverance | Owner: Type: bug | Status: new Priority: normal | Milestone: Component: Runtime | Version: 7.10.2 System | Keywords: eventlog | Operating System: Unknown/Multiple Architecture: x86_64 | Type of failure: None/Unknown (amd64) | Test Case: | Blocked By: Blocking: | Related Tickets: Differential Rev(s): | Wiki Page: -------------------------------------+------------------------------------- Recently I was trying to use ThreadScope to run down a performance issue. I ran into what I believe is a corner case with flushing the eventlog data to disk. The program was generating hundreds of millions of events every few minutes. The function printAndClearEventBuf uses fwrite to flush the buffer to disk. What I observed is that with larger buffers it would only succeed in writing the first 4096 bytes. After it would print out its debugBelch message a number of times the program would crash. It does not crash if not run with the eventlog -l flag. My understanding is that fwrite might need to be called in a loop to ensure that all data is written. fwrite is not guaranteed to always write the entire requested buffer. I don't have a good test case for this, but if there is agreement about potential issues with flushing the buffer I am more than happy to provide a patch. -- Ticket URL: http://ghc.haskell.org/trac/ghc/ticket/11041 GHC http://www.haskell.org/ghc/ The Glasgow Haskell Compiler