I know this will be going back a bit, but I have a problem with compiling some code with ghc-5.04.3. The same code goes through ghc-6.2 with no problems, and until recently there were no problems with ghc-5.04.3 either. But a recent code change has caused the following warning messages from ghc-5.04.3: still has jump to fast entry point: r4HK_entry: leal 12(%ebp), %eax cmpl 84(%ebx), %eax jbe .L55 movl $r4HK_closure, %esi movl -4(%ebx), %eax .L56: jmp *%eax .L55: movl 4(%ebp), %esi addl $12, %ebp movl $r4HK_fast2, %eax jmp .L56 There are about 350kb of very similar messages: still has jump to fast entry point: r3R_entry: still has jump to fast entry point: s4K3_entry: and so on. Does anyone have any idea what these mean, and how I might go about fixing them? Although they are only warnings, I'd like my software to continue to be portable to older versions of ghc if possible. Regards, Malcolm