Re: [Haskell-cafe] Multicast receiver thread fails to receive last few messages

altenratively, you can compile your module with -fno-omit-yields, which adds a yield to no allocation loops On Tue, Sep 23, 2014 at 2:26 PM, Ben Gunton wrote:

Indeed, this was the issue. Took Benno's advice and added a yield, and it works as I hoped it would. Thanks!

On Tue, Sep 23, 2014 at 10:46 AM, Gregory Collins

...

wrote:

...

Since this is UDP, you may be overflowing your device queue. Linux helpfully won't return ENOBUFS in this case but will instead just drop the packet on the floor. The threadDelay fixes this by yielding the processor so that the consumer thread can dequeue packets.

G

On Tue, Sep 23, 2014 at 8:14 AM, Ben Gunton wrote:

...

I am trying to send multicast messages from one thread, and receive them on another. The sending thread reads lines from a file and sends them. However, the receiving thread does not receive all the messages - it seems to miss the last 10 message or so. If I run other programs to listen for the multicast message, they receive them fine. So I think the issue is something to do with receiving, not sending. I keep the program alive with a threadDelay, so it shouldn't be halting prematurely. If I add a small delay after each send, it works fine. And if I make the input file smaller, it works fine.

On the provided data file, on my system (64-bit Ubuntu, GHC 7.8.2), the receiver fails to receive lines 125-140. Compiled with no optimizations.

Thanks for any help!

The relevant code snippets are below, and the sample data file and full program are attached.

-- Loop to receive all the packets let receiveMulticast = do (msg, _) <- recvFrom recvSock 32628 putStrLn . BS.unpack $ BS.take 100 msg receiveMulticast _ <- forkIO receiveMulticast

-- Send every line from a file as multicast message inputFile <- openFile "data" ReadMode fileLines <- BS.lines <$> BS.hGetContents inputFile let sendMulticast msg = do sendTo sendSock msg addr -- Receiver FAILS to receive last few messages unless this -- thread delay exists... why?! -- threadDelay (1) mapM_ sendMulticast fileLines hClose inputFile

threadDelay (1000*1000*1000) -- Delay for 1000 seconds

_______________________________________________ Haskell-Cafe mailing list Haskell-Cafe@haskell.org http://www.haskell.org/mailman/listinfo/haskell-cafe

-- Gregory Collins

_______________________________________________ Haskell-Cafe mailing list Haskell-Cafe@haskell.org http://www.haskell.org/mailman/listinfo/haskell-cafe